







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cabinets & Countertops in Winchester, NV: What This Job Actually Costs and Takes
New cabinets and countertops in Winchester, NV typically run $14,000 to $45,000 for a full tear-out and replacement, and a typical single-family kitchen takes three to six weeks from demo to final template. Cabinet installation alone sits at $4,000 to $13,000, countertop installation at $2,000 to $6,500, and an island at $3,000 to $10,000. We do the work with background-checked, uniformed technicians and quote it upfront, so the number you see is the number you pay. Call (888) 329-9414 for a free estimate.
How We Run a Cabinet and Countertop Job, Stage by Stage

Most contractors describe cabinets and countertops as a single blob of work. It isn’t. The stages matter because each one locks in a decision the next one depends on, and getting the order wrong is how kitchens end up with a drawer that won’t clear a dishwasher or a seam that lands dead center in the sink.
Stage 1: Measure and layout (day 1, 2 to 3 hours)
We laser-measure the room, mark stud locations, check floor level, and confirm appliance openings against the actual boxes you’re buying. You decide the cabinet layout at this stage, and this is where you lock the sink and range positions, because moving either one changes the whole plan downstream.
Stage 2: Demo and prep (days 2 to 4)
Old cabinets come out, the wall behind them gets inspected, and we repair water damage, out-of-plumb framing, or missing backing before anything new goes up. You decide nothing here; this is our work. But if we find rot behind a sink, we stop and show you before we cover it.
Stage 3: Cabinet install (days 5 to 7)
Base cabinets set level and shimmed, wall cabinets hung to a consistent line, fillers scribed to the wall, crown and light rail added. You decide door style and hardware pulls before this stage starts, since those get ordered in advance.
Stage 4: Template (day 8, roughly 60 to 90 minutes)
Countertops are templated only after cabinets are fully installed and level, never before. The fabricator cuts a physical or digital template on site. You decide edge profile and seam placement at the template, and this is your last real chance to change your mind without a re-cut charge.
Stage 5: Fabrication and install (days 9 to 18)
Stone counters fabricate off site and install in a single visit, then the sink, faucet, and dishwasher get connected. You decide the sink and faucet model before template, because undermount sinks need to be on site for the fabricator to mount.
If your job is part of a broader scope, we scope the cabinet package inside our kitchen remodeling service and keep one crew and one schedule for the whole thing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
The choices that move both your budget and your daily experience, with honest trade-offs:
- Stock cabinets: the cheapest route, $4,000 to $7,000 installed for a typical layout, with limited sizes and fewer finish options. Fine for rentals and tight budgets.
- Semi-custom cabinets: the middle and most common pick, $7,000 to $13,000 installed, with real size flexibility and full overlay doors. This is where most Winchester homeowners land.
- Full custom: built to the inch, $13,000 and up, worth it for odd angles and non-standard rooms, hard to justify in a square box.
- Refacing instead of replacing: new doors and veneer on existing boxes, $3,000 to $6,000, and a good fit when the boxes are solid and the layout already works.
- Laminate counters: $2,000 to $3,500 installed. Affordable, but seams show and heat will mark it around a hot pan.
- Quartz: $3,500 to $6,500 installed. Non-porous, no sealing, holds up to daily abuse, and the default pick for most of these kitchens.
- Granite and other natural stone: same range, but needs periodic sealing and every slab is different, which some people love and others don’t.
KraftMaid and Cambria live on our partner list, so we can price those lines directly rather than guessing at a showroom tag.
What Cabinets & Countertops Costs in Winchester, NV

Expect $14,000 to $45,000 for a full replacement, and $9,000 to $20,000 for a smaller or partial scope. The spread inside that range comes down to five things:
- Cabinet grade and linear feet: a 12-foot run and a 22-foot run are not the same job, and the box quality doubles the cabinet number on its own.
- Counter material: laminate versus quartz versus a full slab island face swings the counter portion by thousands.
- Layout changes: relocating a sink or range moves plumbing and electrical, which adds $1,500 or more and lengthens the schedule.
- Condition behind the walls: water damage, out-of-level floors, or old galvanized supply lines found at demo.
- Island and extras: a new island adds $3,000 to $10,000, and a backsplash adds $800 to $2,500.
A written estimate from us is line-itemed: cabinets, counters, demo, install labor, plumbing and electrical tie-ins, and haul-away. What it won’t include unless we flag it is appliance cost, and anything hidden that demo uncovers. Upfront pricing means no change order surprises after the walls open. Call (888) 329-9414 to get yours scheduled.
See the difference
Before
After
Before
After
Before
AfterWhat Winchester Homes Specifically Do to This Job
Winchester is an unincorporated Clark County strip wedged between the Las Vegas Strip and the airport, ZIP 89109, and it’s built around tourism and hospitality rather than single-family housing. That changes the cabinets and countertops work in ways it doesn’t elsewhere in the valley. The housing stock here skews to high-rise condos, timeshare and hotel properties, and aging mid-century apartment complexes along the Convention Center corridor, so much of what we replace is multifamily or hospitality-grade cabinetry that’s been through years of tenant turnover, not a suburban tract kitchen built in one era.
Permitting runs through Clark County, not a city office, and that matters when you’re coordinating a unit turn in a building with resort operations on the ground floor. Deliveries and staging have to be scheduled around loading docks and valet traffic, and crews work around 24-hour operations rather than a normal business day. Hop on the airport approach and you’ll understand why. The heat matters too: summer highs over 105°F make interior cabinet work the sensible choice while exterior trades wait for an early-morning window.
If you’re converting underused space into a rentable unit, homeowners and property owners here often pair this with a Garage Conversion ADU in Winchester or a New Detached ADU in Winchester, where the cabinet package runs on the same schedule as the rest of the build. We cover the whole Winchester corridor, and if your scope is bigger than the kitchen alone, the team behind our Kitchen Remodeling in Winchester page handles the full build from foundation to finish line. We work with James Hardie and Plant Prefab materials where structure and exterior enter the picture, and every job is backed in writing by the 730-Day Done Right Promise.
Serving Winchester, NV – Our Local Coverage Area
We serve Winchester and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Cabinets & Countertops in Winchester

Three to six weeks from demo to final install for a typical kitchen, with stone counters adding roughly 7 to 10 business days of fabrication after template. Condo and multifamily jobs in 89109 can run longer because delivery windows and building access dictate the schedule. Call (888) 329-9414 to get a start date on the calendar.
Replacing cabinets and counters in the same locations usually doesn’t require a permit through Clark County, but relocating plumbing, moving electrical, or adding an island with a sink or cooktop does. We pull the permits and pass the inspections when the scope calls for it, and we tell you upfront which box your job falls into. Call (888) 329-9414 with your layout and we’ll sort it out.
Yes, and most jobs here stay put, which is what keeps the price at the low end of the range. Keeping the sink and range in place avoids $1,500 to $3,000 in plumbing and electrical work and shaves a week or more off the schedule. A load-bearing wall removal is a separate conversation and needs structural review. Call (888) 329-9414 and we’ll walk the wall with you.
Full replacement runs $14,000 to $45,000, cabinet installation alone is $4,000 to $13,000, and countertops are $2,000 to $6,500. Smaller or partial work lands at $9,000 to $20,000. We’re Insured & Bonded and $1,000 off projects over $10,000 applies, along with 0% financing for 18 months. Call (888) 329-9414 for an exact quote, and estimates are free.
Every cabinet and countertop job is covered by the 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction. If a joint fails, a door sags, or a seam misbehaves, we come back and make it right. Calls are answered by a live person, 24 hours a day. Call (888) 329-9414 to schedule your free on-site estimate.
Get Your Cabinets & Countertops Priced in Winchester
Call (888) 329-9414 to schedule a free on-site estimate for cabinets and countertops in Winchester. A live person answers, day or night, and we’ll set a time that works around your schedule. On the visit we measure the room, talk through cabinet grade and counter material, and hand you a written line-item quote with the full price and no surprises. No pressure, no deposit to get a number.
Written by the team at Groundwork Construction Co.












