







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Summerlin, NV: What It Costs and How Long It Takes
A chain link fence in Summerlin typically runs $3,500 to $9,000 for a residential property, depending on linear footage, height, gauge, and gate count. Most jobs are measured one week, approved by the HOA in two to four, and installed in a single day or two once everything clears. Call (888) 329-9414 to schedule a free on-site estimate, and we’ll walk the property line with you and put real numbers against your footage before anything is ordered.
How We Build a Chain Link Fence in Summerlin, Start to Finish

The sequence matters here because Summerlin is HOA-governed, and the order of operations is different than a fence in an unincorporated part of the valley. Here’s what actually happens.
Stage 1: Site walk and line layout (about an hour, week one)
We walk the property with you and mark the actual fence line with stakes and string. This is where you decide height, gate placement, and whether the fence ties into an existing wall or runs free-standing. We also note what’s underground along the line: irrigation, pool plumbing, gas stubs. On Summerlin’s west-valley lots, that walk often turns up caliche just below the surface, which changes the equipment we bring on install day. You get a written line-item quote from this visit, not a phone number.
Stage 2: HOA submittal and Design Review (two to four weeks, usually)
Summerlin’s community associations require architectural approval before a fence goes up, and many villages have standards on height, color, and where fencing can sit relative to the side yard and street. We put together the submittal package – plot plan, fence detail, color and material spec – so your board has what it needs in one pass. This stage is the biggest variable in the whole timeline, and it’s not something we can compress. If your village’s board meets monthly, you may wait for the next meeting date.
Stage 3: Permitting and utility locate (one to two weeks, runs parallel)
Clark County permitting and the 811 utility locate happen alongside the HOA review. Anything over six feet, or any fence near a pool, tends to draw more scrutiny. We pull the permit and schedule inspections as part of the job – you don’t chase paperwork. If your line crosses a shared property boundary, we’ll flag that early so you can sort the neighbor conversation before posts go in.
Stage 4: Install day (one to two days for most residential runs)
Posts get set in concrete, typically 24 to 30 inches deep and spaced at standard intervals. On Summerlin’s alluvial-fan soil, that digging sometimes hits cemented hardpan, and we bring a rock auger or mini-excavator for it rather than hand-digging for hours. Mesh, top rail, tension bands, and gates go on after the concrete cures. Gates get set with hinges and latches checked for swing and alignment. A typical 150- to 200-foot residential run finishes in one long day.
Stage 5: Inspection and final walk (same week as install)
The county inspection clears once posts and heights are confirmed, then we walk the fence with you. We check gate swing, look for any sag in the mesh, and confirm the tension wire is set. If something isn’t right, it gets corrected before we leave. Your fence carries our 730-Day Done Right Promise – if it’s not right, we make it right, in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Actually Change a Chain Link Fence
Chain link isn’t one product. The spec sheet you pick drives both the price and how long the fence holds up against Summerlin’s UV and wind.
- Gauge (wire thickness). 11.5-gauge is the residential standard and holds up well. 9-gauge is heavier and worth it for side yards that take wind or dog traffic. 12.5-gauge is lighter and cheaper, and we generally steer homeowners away from it on a permanent fence.
- Coating. Galvanized steel is the budget option and will show rust over time in the desert. Vinyl-coated (usually black or green) costs more up front but handles Summerlin’s intense UV far better and looks cleaner against stucco. Black coated is the most common choice we see here.
- Height. Four feet is standard for property lines. Five or six feet for privacy and dog containment. Anything over six feet in Summerlin usually triggers extra HOA review and possibly a taller-post spec.
- Top rail and framework. A top rail and tension wire keep the mesh from sagging. Cheaper jobs drop the tension wire; we don’t, because it’s the difference between a fence that stays tight for a decade and one that bows by year three.
- Gates. Walk gates are standard. Drive gates need heavier posts and a different hinge setup. Every gate is a place where hardware quality shows, so we use commercial-grade hinges and latches rather than the stamped ones that come in a kit.
- Privacy options. Slats or privacy tape weave through the mesh when you want screening without switching to another material. It’s a cost add-on, and it does catch wind, so post spacing may need to tighten.
For homeowners pairing fence work with hardscape in the same yard, we also install Fence Installation across the full range of materials, and our paver work uses brands like Belgard and Tremron where the border or patio meets the fence line.
What a Chain Link Fence Costs in Summerlin, NV

Residential chain link fence in Summerlin runs $3,500 to $9,000. That spread is real, and these are the variables that push a job toward one end or the other:
- Linear footage. A typical Summerlin side-and-back run of 120 to 180 feet sits in the low-to-middle of the range. A full-perimeter job on a larger lot in Summerlin West pushes toward the top.
- Height and gauge. Upgrading from 4-foot 11.5-gauge to 6-foot 9-gauge coated adds meaningfully to the total, plus the taller-post and HOA review costs.
- Gate count. Each walk gate adds cost, and a drive gate adds more because of the heavier framework and hardware.
- Site conditions. Caliche is the wild card. If posts hit hardpan, rock-augering or excavation adds time and equipment. We flag this at the site walk so it’s in the quote, not a surprise line item later.
- Demo and haul-away. Removing an existing fence adds labor and disposal. Some Summerlin lots have old fencing buried in landscaping, which takes longer to clear.
Every written estimate is itemized: footage, gauge, coating, gate count, post depth, demo, permit, and inspection. The number you see is the number you pay, and if the job grows beyond the quote, we tell you before we do the work, not after.
See the difference
Before
After
Before
After
Before
AfterWhat Summerlin Homes Do to a Chain Link Fence Job
Summerlin’s housing stock is overwhelmingly recent – mostly 1990s-through-2020s stucco-and-tile homes across villages like The Ridges, Red Rock, and Summerlin West. That matters here because the fencing being replaced is usually the original builder-grade chain link, and the property line often runs tight against a side yard or a shared wall in the denser townhome and alley-load pockets. Tight clearances mean the fence line has to be set precisely, and gates need to swing without hitting a wall or a neighbor’s landscaping.
The bigger local reality is approval. Summerlin is a master-planned, HOA-governed community built largely by the Howard Hughes Corporation on former federal land, so a fence here runs a two-front approval process: Clark County permits plus community association sign-off. That extra layer doesn’t exist in neighboring Las Vegas or North Las Vegas, and it’s the main reason a chain link fence in Summerlin takes weeks longer than the install itself. Add the wind-exposed terrain toward Red Rock, which drives dust and occasional monsoon drainage concerns along fence lines, and site grading becomes part of the conversation. Permits get pulled and inspections passed on our end; you don’t chase the county.
Serving Summerlin, NV – Our Local Coverage Area
We serve Summerlin and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked About Chain Link Fence in Summerlin

The install itself usually takes one to two days. The full timeline from signed quote to finished fence is typically four to seven weeks because of HOA architectural review and county permitting. Call (888) 329-9414 for a site walk and a realistic date range for your village.
Yes. Summerlin’s community associations require architectural approval, and Clark County permits apply to most fence work, with extra scrutiny for anything over six feet or near a pool. We handle the submittal package and the permit so it’s one process for you.
Usually yes. We locate irrigation, pool plumbing, and gas lines along the fence line at the site walk and route posts around them. If a post has to move, we adjust the layout before digging, not after.
Residential jobs run $3,500 to $9,000, depending on footage, height, gauge, coating, and gate count. Caliche excavation and demo can push a job toward the high end. Call (888) 329-9414 for an exact quote – estimates are free and itemized.
Every chain link fence we install is covered by our 730-Day Done Right Promise on workmanship, in addition to the manufacturer warranty on materials. If something isn’t right, we come back and make it right.
Get a Free Chain Link Fence Estimate in Summerlin
Call (888) 329-9414 to schedule a free on-site estimate for your chain link fence in Summerlin. We’ll walk the line, check for caliche and buried utilities, talk through gauge and coating options, and hand you a written itemized quote the same visit. If you’re planning a wider yard project, this often pairs with Fence Installation in Summerlin scope or with Door Installation in Summerlin on a gate or entry upgrade, and we can quote it together. We cover all of Summerlin, and homeowners often pair this with ADU Site Prep & Utilities in Summerlin when a fence line moves for a new structure.
Written by the team at Groundwork Construction Co.












